##############Fax-2-Email Configuration procedure#################voice service voip no supplementary-service sip refer no supplementary-service sip moved-temporarily### Remove these lines if they are there by using the no command######Enabling the Fax Code, be Aware the UC-500 will need a reboot###fax interface-type fax-mail!!!!!!!!!You must reload the router!!!!!!!!!!!!!fax receive called-subscriber <Enter station ID>mta send subject Faxmail messagemta send postmaster mailer@xyz.yourdomain.commta send mail-from hostname yourdomain.commta send mail-from username $s$mta send server <Enter SMTP Server Address here> port <Enter SMTP Port Number, usually 25>###This section is pretty straight forward, use a station ID number that wont######Conflict with any other assigned numbers, so far tests have shown you can######Use up too 6 characters for this, no problems have been encoutered doing so###########Setting up your Dial-Peer section############dial-peer voice 2500 mmoipdescription FAX to EMAILservice fax_on_vfc_onramp_app out-bounddestination-pattern 123AAAA123information-type faxsession target mailto:faxmail@yourdomain.com###This can be pretty much kept the way it is, you dont really######Need to change much other then the obvious mailto: ######Make sure 2500 does not conflict with another DP Entry######Check this by typing "sh run | s dial-peer voice 2500 mmoip"######If nothing shows up then you can use this number otherwise######Pick create a new one that wont conflict with any other one######PRI Inbound DID management for <What ever your Fax # is>###voice translation-rule 19 rule 1 /^12345678900$/ /123AAAA123/###Replace 12345678900 with your fax line number######Matching translation profile###voice translation-profile DID_Called_XX translate called XX translate calling 1111###Where XX is shown, put in there the respective number, this could be######Your existing translation profile for your Fax line, it can be used###### Just modify the translate calling to suit what ever is allready######Coded into your system, if this is not correct it may not work######PRI DID Inbound###dial-peer voice 2501 pots description DID PRI-12345678900-XX service onramp translation-profile incoming XXXXXXXXXXFax_Called_19 incoming called-number 12345678900 direct-inward-dial port 0/2/0:15###Again "X" is used to replace what should be there, or might be there######This is all dependent on how you programmed it to begin with######Where 12345678900 is used, please put in there your FAX DID######Note if you are using a service number such as 1800.. for your######Fax Line, make sure you use the DID number this Special number is######Pointing to at the carrier end##########################################