how to navigate to aci-api? how to know all uri for rest api? is there easy way?
how to navigate to aci-api? how to know all uri for rest api? is there easy way?
I can't figure out how to get MSO 2.2.4e installed in vCenter following the installation guide: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/aci_multi-site/sw/2x/installation/Cisco-ACI-Multi-Site-Installation-Upgrade-Guide-221/Cisco-...
I am practicing ACI lab from cisco. I am accessing the LAB through GUI. Is there any way to use CLI command from GUI portal itself ?
Hello All - I am preparing for DCACI 300-620 certification Exam. Can you refer a discussion forum / group to collaborate and discuss the exam experience and preparation materials? Thanks regards,Sairam
Hi all, i have:EPG-10 (10.10.10.2, 10.10.10.3 ) link BD-10 (gateway 10.10.10.1/24)EPG-20 (10.10.20.2, 10.10.20.3 ) link BD-20 (gateway 10.10.20.1/24)i not intergrate VMM domain in ACI and i want create useg EPG (10.10.10.3, 10.10.20.2). can i do it?...
Hello all--I'm working on a transparent mode service insertion. I'm using an ASA 5510 running 9.17. From the PBR white paper https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-pape...
Hi All, We have encountered a problem related to MAC flooding/wrong learning with ACI fabric recently. ACI version : Version 4.1 EPG(VLAN) node getting learned with some other EPG(VLAN). For eg: EPG-10(10.100.100.0/24) node(s) MAC/ARP started learn...
Hello FreindsKindly , Help me clear the below Qeustions1)How is BD different from VLAN? 2)Can an EPG point towards more than one Bride Domain3)What is need to have more than one Bridge domain in same VRF? 4)Why is there need to configure Route Refl...
Can someone please explain to me what this means and the impact. How can i clean the storage to bring the utilization down.Thanks
Hi folks, just did a clean and fresh install of MSO 2.2.3i ..Was also reading through all the documentation and found two default logins after install:"admin / we1come!" for older releases"admin / We1come2msc!" for newer releases..However I am comple...
Hey Folks, I hope somebody has further insight on my issue here.I am trying to monitor my ACI fabric via SNMP Polling (against the OOB IP addresses).Tried this running earlier 4.2(2f) and now 4.2(3j). What I already did and already works:Under Fabric...
We upgraded ACI from 2.2(2k) to 2.2(4p) and upgraded one group of leaf switches after APIC/spine upgrade.APIC showed those leaf switches were upgraded successfully, but actual leaf switches were not reloaded and not upgraded.Have you seen such a thin...
Hi, I'm looking for some guidance. We have aci in network centric mode, and have began migration of services into aci using a physical and a vmm domain, these vlans are statically configured as we are trunking the vlans into aci while we migrate, how...
Hey folks, hope we're doing well.I got a topology where traffic got redirected to a pair of CheckPoint firewalls using PBR. Since there's only one logical interface for each node connecting to the ACI leafs, I also use them as management interface (t...
Hi , I am migrating a traditional network to ACI. I have a L3 (SVI) in the current Cisco core (10.200.1.0/24). The same network consists of 2 FW gateways as mentioned above in the same network. ie 10.200.1.100/24 and 10.200.1.150/24. I know we ca...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-26-2024 10:27 AM | ||
04-22-2024 03:41 AM | ||
04-17-2024 06:22 AM | ||
04-04-2024 03:57 AM | ||
04-04-2024 02:29 AM |