Hi, We need to clear all active sessions.We can see all active sessions with commands show aaa sessions or moquery -c aaaActiveUserSession, but how can we deleted it?Thanks.
Forum Posts
We have an use case to integrate Checkpoint Firewall with Cisco ACI in Policy Based Redirect mode. With this deployment, Firewall will have NAT functionality (Private IP to Private IP NAT).In this scenario, I would like to know if this is supported i...
Hi,Let's say I have two ESG with a contract inherited from the EPGs due to the EGP-to-ESG selector. Then I create a new contract with the same ports than the inherited and I provide/consume it in the same way the inherited contract is. When does this...
Hi there, Anyone has experience with floating ip address and BGP in ACI? As far as I know BGP is not sending Hello packets using floatng ip address. Configured and tested it in physical domain, but did get the BGP neighborship up. https://www.cisco.c...
Resolved! Hard set speed and duplex in Cisco ACI?
Hello All,How can I hard set duplex and speed / change from auto negotiate in Cisco ACI?Thank you,J
Resolved! Kubernetes integration with ACI
Greetings all,I have a prod ACI fabric running 4.2(7s) in network-centric. Connected to this fabric is a VMware cluster consisting of around a dozen physical ESXi hosts. We're doing VMM integration, so there aren't any static path bindings for these ...
I have an issue when creating L3out with interface type of virtual port channel, the path box is empty, although I created interface policy group of type vpc. The same issue when adding static port of type vpc for application EPG
Hello all,Kind of a crazy question but here goes. If I have a production APIC with a failed SSD drive, and I need to get it replaced ASAP, could I go decommission one of my LAB APIC's and then go into that LAB APIC and wipe its SSD drive and then tak...
Hi, In the attached design, and in the same vrf-X: we have EPGs that must go through the firewall and others directly to the ASR. With this design, it can cause routing problems in VRF-X? because we will have a route leaking from VRF-X-OUT to VRF-X a...
I know this is something super simple, I just haven't configured these in a while. I have a VPC created, and it is tied into and AEP, Interface Selector, VLAN Pool, and an External Routed domain. All of these look fine with no faults, and the L3Out...
HI Team , Can we check the running configuration of the interface via cli of LEAF switch ?
Hi everyone,I wonder if there is a way or CLI command to identify the L3Out and External EPG from where the fabric is reaching and external endpoint.We have several L3Outs and Ext EPGs and I'm in the need to quickly find from where an IP is being rea...
Hi All , I'm trying to check SFP combability ( with below Cisco ACI models : C9336C-FX-2 & 93180YC-EX. Firmware version is : 14.2(4i) SFP proposed models are : SFP-10G/25G-CSR-SR and / or SFP-25G-SR-S i couldn't find them in the optics matrix shee...
Hi experts,I'am currently using Ansible to manage App/Epg in ACI.Eveything work as expected to create or delete the objects.But now, I would like a playbook that delete the epg and after that delete the app profile but only if this one is empty (no e...
Hi, I have a port set up in APIC with an Interface Policy Group and (for sake of example) 20 separate epgs- is there a way (simply) to reset the port to default (no config), rather than going into each epg and removing the port, then going into the p...
