10-03-2024 08:08 PM
Hi,
I'm trying to connect to cable between APIC-SERVER-L2(VIC1225 with 10GBASE-T) and C93108TC.
The SFP vender is the Interlink.
A link of C93108TC is up but, APIC's side is down.
Is link possible to be up ?
apic1# cat /proc/net/bonding/bond0
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: eth2-1
MII Status: up
MII Polling Interval (ms): 60
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth2-1 => 10G-SR
MII Status: up
Speed: 10000 Mbps
Duplex: full
Link Failure Count: 1
Permanent HW addr:
Slave queue ID: 0
Slave Interface: eth2-2 => 10G-T
MII Status: down
Speed: Unknown
Duplex: Unknown
Link Failure Count: 6
Permanent HW addr:
Slave queue ID: 0
admin@apic1:~> ethtool eth2-2
Settings for eth2-2:
Supported ports: [ FIBRE ]
Supported link modes: 10000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: No
Supported FEC modes: Not reported
Advertised link modes: 10000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: No
Advertised FEC modes: Not reported
Speed: Unknown!
Duplex: Unknown! (255)
Port: FIBRE
PHYAD: 0
Transceiver: internal
Auto-negotiation: off
Cannot get wake-on-lan settings: Operation not permitted
Current message level: 0x00000000 (0)
Link detected: no
<C93108TC>
show interface status
Eth1/48 -- out-of-ser trunk full 10G 10g
thank you
best regards
10-04-2024 11:59 PM
Hello @JunSungKim2765 ,
I am a bit confused by your statement referring to VIC1225T and the command output after it. If your APIC has VIC1225T then you'll need copper cables because the VIC has only copper ports. But if you have VIC1225 then you'll need fiber optic cables.
However, from the command output you mentioned and the eth2-1 which is working on 10G SR, I am guessing that your APIC has VIC1225.
Kindly rate helpful posts.
-Wassim
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide