cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
880
Views
0
Helpful
1
Replies

Linecard upgrade leaves invalid-paths where portcounts were reduced (F1209)

joshua.james
Beginner
Beginner

When upgrading from a 36-port linecard to a 32-port linecard on a 9508 chassis, the reduced ports (33-36) are left in a invalid-path state.

 

Apparently the fabric is still trying to configure these ports, raising fault F1209:

 

Fault delegate: Configuration failed for node SPINE101, Out of Service Fabric Policy default topology/pod-1/paths-101/pathep-[eth1/35] due to invalid-path

 

Configuration failed for node SPINE101, Out of Service Fabric Policy default topology/pod-1/paths-101/pathep-[eth1/36] due to invalid-path
Type:
Config

 

 

How can these policies be removed, now that ports 33-36 do not exist or show up to be assigned or modified?

1 Reply 1

thebestusername
Beginner
Beginner

Looks like this might be CSCwb49743.  The status is "Fixed" but it doesn't say in what release.  Affected release is 4.2(7f).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers