Creating L4-L7 for an Independent Active Nodes FW

[Aaron_un]

There are 3 different modes that we can insert the FW service node into the fabric, could you explain how different the config is for the last method(Independent Active Nodes), on the following two menus I included?

If I am not wrong the last method is consisted of 3 independent firewalls.

[Sergiu.Daniluk]

Hi @Aaron_un 

The details under the "Independent active nodes" diagram, kinda explains what's going on:

- in the PBR policy you will have multiple IP/MAC entries, each representing one of the active node

- in the L4-L7 device configuration, you will configure all your active FWs under the same node. Basically, where you see in 2nd picture "ASAv1" and "ASAv2", there is where you will have all your active nodes. 

Cheers,

Sergiu