Real Servers Outside ACE Equipment

[fabricio.monte]

Hi All,

Usually, I configure real server and their default gateway is inside a vlan in the own ACE module.

I configure the real servers, serverfarms and the probes and works fine.

Now I have to configure a load balance where the real servers are outside the ACE and in another equipment in the network.

I would like to know if is it possible and if is the same way if the real server  IP address were in a vlan in the ACE module.

Regards,

Fabricio

[Surya ARBY]

no changes to the config, except that you will have to enable source NAT on your virtual server and use a NAT pool on the interface vlan facing the next hop of the route to reach the ressources