Cisco Catalyst Center

Hi,I am trying to upgrade a DNAC 2.1.2.7 to 2.2.2.4 and the AURA tool says I might be hitting bug CSCvy55791/CSCvx83602.Check: #13:Expiry of registry CA cert Error:#01:Registry CA not found - check CSCvy55791 - file /etc/docker/certs.d/maglev-registr...

We have 2 DNAC Active/Standby and the witness, the witness is located to a sort of third Data Center.All 3 DataCenters have access to the MPLS through a dedicated PE.The witness has two way to reach DNACs:1) Using a dedicated DWDM link which directly...

Kindly your advice in helping us in the best mapping for spread AP in the management floor that could help us to cover all our employee in the company our company included 400 employees and each employee uses 2 devices your help, please? 

Good day community, Is there a clear feature comparison available between these 2 offerings? I read that licenses can be reused and that there is a lack of feature parity, however I would like to know what works now, is planned for when, and the impl...

Hi All, I am doing some reading into ITSM integration with DNA Center and can see it can be done with and without the DNA Center App. I would like to know if there are any major differences when using the App, so i can understand if we need it in our...

Very Code is a privately owned, well-known Software company located in Kathmandu. TheManagement of Very Code has purchased a 3 story building in the heart of Kathmandu valley.They are planning to make it one of the state-of-the-art companies in Nepal...

Hi everyone, I should permit on my firewall the ip address of the DNA that goes to internet, this process is a little slow so I don´t want to make a mistake. I have a 3 node cluster and only two intefaces per node, the enterprise and the cluster inte...

Hi, I am trying to connect to the internet through CISCO Anyconnect.  I put in the wrong password and it keeps auto connecting, there is no way I can see to put in a new password.  All the suggestions online seem to show how to fix this, assuming I c...

In our country there are some trials for 5G, so now I want to connect these two networks combined with idm kuyhaaTo check the exact speed which users will get.Help me in this project.

Hello, We used the initial maglev setup to configure our DNAC interfaces. We are using both, management and enterprise interface. It is the basic configuration :10.254.0.0/16 => DG 10.20.0.254 on management port We wanted to change the default GW or ...

I was forwarding a port for public viewing using the public ip. Now the internal ip is 192.168.1.150 and the public ip is 41.xx.xxx.189  I forwarded using putty shell and had the following commands ip nat inside source static tcp 192.168.1.150 80 41....

Guys, Wchich Jinja version / features are used by Cisco DNAC in templates? I've tried some commands, like 'regex_search' filters, and it does not work or cause errors. thanks,robert