C9500 Switch Network Advantage License expired after 3y BGP running, what will be the impact bgp is still running
Forum Posts
Regarding SNMP settings on the Catalyst 1300 switch,it is different from the CLI commands for other 9000 seriesbut how do I set it up to send traps to an SNMP server?I would be grateful if you could show me the specific commands.This is a basic quest...
I created a velocity template for my Day0 PnP config, but I cannot figure out how to get it to show up as an option in the OnBoarding Template(s) tab, it will only show up in the Day-N Template(s) tab. I created a velocity template called Day0 Base T...
Hi,I have been trying to find UK EU EMC information on the C1000-24T-4G-L switch on the Cisco approvals search page with no luck. Can anyone help me with finding it please?Many thanks,Leebert
Thank you for joining us for the Expert Insights Series on Cisco Catalyst Center: Empowering Catalyst Center Excellence! Our Customer Success Specialists Max Tellez and Irvin Mendiola will be available from June 26, 2025 through July 11, 2025. Wheth...
Resolved! SDA: Edge node behind Edge node
Good morning Just a simple question about the physical design of a sd-access topology. Is it supported that an Edge Node is attached to another Edge Node ? Kind regards
I am trying to write a template that sets the switch VTP mode 3, configures domain and password and then depending if the hostname contains core or distro, sets the mode to server, and if it's core to also set to primary server.For the core, via cli ...
Dear all, I appreciate your help with this matter.We are facing a persistent issue with the support-service on our Cisco Catalyst Center appliance (PID: DN1-HW-APL, Version: 2.3.7.6-70319). The service remains in a CrashLoopBackOff state, even after ...
Is there a way to create additional device roles in catalyst center? I want to create a device role call Voice gateways. The current roles does not fit our voice gateways devices. They are classified as either core or border router.
Resolved! Catalyst Center 3.1.3 on AWS ?
Anyone @ cisco here know what the timeframe is for v3.1.3 to be added to the AWS marketplace?Right now I'm using v2.3.7.9 for lab POC & writing training content... should I be waiting for v3.1.3 ?Is there a big change in the UI between v2.3.7.9 and v...
Hello everyone,today I want to ask how I can enable pure L2 switching in a SD-Fabric Site.I attached a little draw and a tooltip info form CatalystCenter at the end of my post.I did the following to achive this but it don't work.I go into my Site B, ...
Hi all,Can anyone tell me what is the major difference between VTP version 1 and version 2 apart from consistency check, token ring support in version 2.
Can we do wireless upgrade from DNAC simultaneously
Hi, I'm trying to find a way to display a list of access switches without a redundant link to a neigbouring switch. The network reasoner can show me a single device without a link to two distribution switches, but sometimes we have a small ring of s...
Hi Community,I've been upgrading a few Catalyst C9300L and C9300LM, from 17.08.x and 17.09.x to most recent 17.12.04 using Catalyst Center SWIM and noticed that while monitoring a switch with a continuous ping, there are two times that a switch stops...
