Hi, We are now using Genereation 1 of DNA-Center as lab, and recently integrated with a router. We are getting sylogs, and snmp traps, but the assurance shows "no health data" for the device. Dna Center version: 2.2.2.5 Generation 1 Cisco Router p...
Hi all, My company has an existing Cisco 5520 WLC in production. We just got DNAC for testing. I am looking into adding it into DNAC so we can have heat maps etc. I think I'll have to use OTT method since we do not having any SDA setup yet. My questi...
Recently ran into this error in the DNAC UI when attempting to replace the certificate under System Settings: 'Issuer should be equal to Subject for root cert.' This is a banner that quickly pops up in RED and disappears within about 10 seconds. Lon...
Hi, I have some 9300 switches with advantage licenses that needs to be added to a stack with another 9300 with an essential license. The switches aren't compatible for a stack due to different license levels, and would like to know how I can downgrad...
Hi All, I am replacing the default DNA self-signed cert. I have followed the steps and have the CSR using the following command (all done in Maglev):cat dnac01-sha256-2048.csrThis has been signed, and l have concatenated this with my Root CA. The que...
hi,i would like to know that if i have an idea about the improvement to Cisco's networking products, is there anyone accessible on this community? looking forward to your reply. kind regards
Hello dear, I'm running an SDA Fabric with DNAC 2.2.2.8.On the Fabric page, I get Information Alerts (see enclosed screenshot) at the Site level. Same alerts are displayed when navigating down the hierarchy. My question are:- Considering I'm on a spe...
Hi all, Is there any DNA Center SD ACCESS Pre-Deployment Questionnaire / Check list available ?. Thank you
Hi everyone I have a doubt, how can I add/remove an access list entry from DNA Center to all of the switches added? I have around 300 switches, I want to optimize this task and don't go manually switch by switch. DNA Version: 2.1.2.7 Thanks for advic...
The ENCOR training guide says, " The VXLAN VNID is used to provide both Layer 2 (Layer 2 VNID) and Layer 3 (Layer 3 VNID) segmentation" In SD Access, we are mapping VNs to VNIs. (We are not mapping VLANs to VNIs) So, in SDA, where is this Layer 2 VNI...
I might not use the correct terminology, but here below are what I am confused about by reading Cisco design doc for the solution... According to Cisco SD-Access Solution Design Guide, it states "Typically, fabric WLCs connect to a shared services ne...
I am seeing a frequent 'spikes' in dns queries/requests during peak business hours and I noticed DNA Center Assurance Client 360 under connectivity has a graph that tracks DNS Requests and Responses. Is there a way I can filter, search and or generat...
Hello allI would like to setup a stand alone DNA center running 2.2.2.4 IOS software at two of my Data center . I will install one DNA Center (Type 112) devices at each site and a witness server to complete the requirements for a DR config. Per the...
Hi, I already have implemented an SDA fabric. I also have branch switchs managed by DNAC.I have created 2 application policy (HQ_policy and Branch_Policy) which are identical. I have keep the CVD application application, I have only requalified 2 ms-...
Hello, I would like to implement 802.1x on AP connected on Catalyst 9300.The method used will be EAP-FAST.I have directly configured the 802.1x credentials and the EAP-FAST on the Catalyst 9800 WLC and it works well. With the new DNAC version, it is ...
