Please can someone interpret or convert the viptela commands to cisco IOS sdwan commands
I am planning to replace all our vedges to cisco ISR 1100
All our vedges are managed via cli so i need to convert below viptela commands to cisco IOS sdwan commands
Please can someone share how to configure below command on cisco sdwan IOS-XE routers
| Gre Tunnels for Zscalar internet access |
Vpn 0
interface gre1 |
| ip address <> |
| tunnel-source <> |
| tunnel-destination <> |
| |
| Default Gre route in Vpn 10 |
| ip gre-route 0.0.0.0/0 vpn 0 interface gre1 |
| |
| |
| |
| |
| |
