cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4692
Views
5
Helpful
0
Comments
joemar
Enthusiast
Enthusiast

UCS has a strange problem where you can end up in a state where unassociated blades can be powered on and there is not way in the GUI to power them off.  So they just sit there wasting power.  the only way to power them down is a associate them with a service profile and then shut them down.  So this script automates this by creating a very basic service profile and then associating it to unassociated but powered on blades and turns them off and then disassociates the service profile.  It can be run against a single blade or you can have it do all of the blades in this state.

v0.1.01 - Initially posted release

As always, let me know if you have any comments, questions or suggestions.

Joe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links