Cisco Catalyst Center

I created a velocity template for my Day0 PnP config, but I cannot figure out how to get it to show up as an option in the OnBoarding Template(s) tab, it will only show up in the Day-N Template(s) tab. I created a velocity template called Day0 Base T...

Dear all, I appreciate your help with this matter.We are facing a persistent issue with the support-service on our Cisco Catalyst Center appliance (PID: DN1-HW-APL, Version: 2.3.7.6-70319). The service remains in a CrashLoopBackOff state, even after ...

Is there a way to create additional device roles in catalyst center? I want to create a device role call Voice gateways. The current roles does not fit our voice gateways devices. They are classified as either core or border router.

Hello everyone,today I want to ask how I can enable pure L2 switching in a SD-Fabric Site.I attached a little draw and a tooltip info form CatalystCenter at the end of my post.I did the following to achive this but it don't work.I go into my Site B, ...

Hi all,Can anyone tell me what is the major difference between VTP version 1 and version 2 apart from consistency check, token ring support in version 2. 

Thank you for joining us for the Expert Insights Series on Cisco Catalyst Center: Empowering Catalyst Center Excellence!  Our Customer Success Specialists Max Tellez and Irvin Mendiola will be available from June 26, 2025 through July 11, 2025. Wheth...

Can we do wireless upgrade from DNAC simultaneously

Hi, I'm trying to find a way to display a list of access switches without a redundant link to a neigbouring switch.  The network reasoner can show me a single device without a link to two distribution switches, but sometimes we have a small ring of s...

Hello, I noticed on my DNA Center that my primary ISE appears as "unavailable". After checking, all the prerequisites seem to be in order. However, when editing ( System > Settings > Authentication and Policy Servers) I noticed that no password had b...

Release 2.3.7.9-VA on a fresh installed and  running on a single standalone esxi server with nvme drives, and Intel Xeon Gold 6442Y processors with no other VM's. We see this same issue on a fresh install. Every page is extremely slow to load. Tested...

Hi Community,I've been upgrading a few Catalyst C9300L and C9300LM, from 17.08.x and 17.09.x to most recent 17.12.04 using Catalyst Center SWIM and noticed that while monitoring a switch with a continuous ping, there are two times that a switch stops...

Good afternoon, In Cat Center version 2.3.7.6, the smart account was added correctly, but the Cat9x SW devices do NOT appear in USE from the smart account. Is there any further action needed to make them appear in use? Thanks in advance. Ciro G. Mele...

I am trying to write a template that sets the switch VTP mode 3, configures domain and password and then depending if the hostname contains core or distro, sets the mode to server, and if it's core to also set to primary server.For the core, via cli ...