Cisco Catalyst Center

Hi, I would like to inquire more about Cisco Catalyst switch licensing. For example, my customer purchased a Network Essentials license with DNA Essentials for 3 years and has been using it for one year. Now they want to upgrade to Network Advantage ...

We installed DNAC with pre drafted network settings. but these should be useless now. So we trying to erase build it from scratch. i have used maglev-config reset command but it didnt work. i try to change boot options, so try to prioritise UEFI but ...

Hi Team, I have an issue. Our Customer ordered and catalyst Center. after we power on the UCS and do the initial config for the CIMC. we continue to install the Catalyst Center. but unfortunately when we try to config for the Interface Enterprise, un...

Is there any reason not to deploy TCN's on Edge stacks?  One TCN in each fabric connected by a SD Transit. The edge location is our most cost effective option. Kev.

I have a new site is being built where I have around 20-30 users with wireless requirement. I have decided to use "Fabric in a Box"(FiB) using Cat9300.As I understood that FiB is Border, Control Plan, Edge and Wireless in the same box but I'm confuse...

While provision a switch to the fabric site I came across this issue of the provision conflict. Although the provision template is the same used by the other switches but they had no issue.Attached is the error which pops up in the DNAC.  In order to...

Hello Everyone,We have three DNAC physical appliances in our main Data Center, in case I want to same amount of devices into Backup Data Center is it mandatory to have Witness site? My IP's on Backup DNAC appliances will be different fyi, L3 DR DR de...

I've tried the following kids of Mode button pushes, but none have worked. The switch is stuck on serial console in Meraki managed mode (I want to start over and put it into Meraki Monitoring mode instead...):=========================================...

Hi,I recently migrated my Wired switches from Prime Infrastructure to DNA Centre. I didn't want the migration to impact on any Switch configs at the moment so I migrated all the devices to a site on DNAC specifically for these devices, which has no p...

We have deployed a virtual network which will house multiple SGTs that the outgoing traffic would need higher priority, and it seemed the "Consumer" policies with Application QoS would allow for ensuring only traffic from the specific SGTs to the ext...

I manage a large network consisting of around 150 cisco 9200, 9300 and 9500 switches.I use Cisco DNA Center to manage this network and do all sorts of things.In the DNA, I have found that you can have a geographic map in the fabric and in the network...