Resolved! Firewall
I'm sorry if my question is so stupid. I don't know that is there any Cisco's ASA firewall just have port FE 10/100 or all of product are FE 10/100/1000 and GE? Thanks.
Forum Posts
why is cisco 5520 wireless controller reset itself randomly?
Hi, What options are available for licencing Cisco virtual asa? I know for manual typing activation key in cli. Believe there is also option for via asdm. But if I activate licence at licencing portal on Cisco site, will it be enough for asa that whe...
I might be looking in all the wrong places for the answer for this. And haven’t really found the correct answer from my findings.Is the following switch a layer 3 or layer 2 with some layer 3 functionality?Cisco WS-C2960C-8PC-L 8 Port Fast Ethernet P...
Hey Cisco Community! I have been eyeing my dream intern role at Cisco for a while now, and have been able to get a good amount of relevant work experience of almost 1+ years of product mgmt intern experience that tailors well to thus role.I am applyi...
Help me settle something here. I have pro services set up 2x 8300 routers(active passive) for our wan with 1gb interfaces. Since it’s been set up we’ve been having qos issues. Voice, vpn, etc it’s just a mess! Thing is the 1gb bandwidth is not even b...
Has anyone enabled these on the cat 9ks? We have it enabled on about 120 devices. The data is somewhat useful but we aren't getting the full picture since our routers don't have dna license.Anyways we've had a couple of issues where endpoints have be...
I've been installing a pair of ISE appliances recently and just performed an upgrade from 3.0-3.2 patch 2. Everything went smooth one ISE1, but on ISE2 after the upgrade I was unable to access the GUI and when I rebooted the device the CLI came up as...
What should the upgrade cadence look like for switch code updates in a SDA environment? I.e. for devices like the fabric border/fusion routers, control plane nodes and transit routers? As of right now in following the SDA compatibility matrix and gol...
Apologies in advance if this is the wrong place to ask! I bought a Cisco UCS c220 m3 server and intend to use the embedded controller with my sata drive. Unfortunately it’s not recognising the hard drive, and in the bios it’s not letting me enable th...
If some devices have SBL installed and others don’t, is there a method to upgrade both AnyConnect and SBL on the systems with SBL and only upgrade AnyConnect without trying to install SBL on systems that don’t already have SBL?It doesn’t appear that ...
I can't enter any configuration mode ( eg. route-map, Interface .... ) from global configuration mode before that i try to changed etherchannel access port from etherchannel with sub interface. I found main interface Eth1/8 is not get any RX or TX po...
Hey guys!I, and my team, are new to the networking world, and are working with Cisco PT. We are creating a setup for our exam in physical, but, the main wiring closet is too big for the room we want it in (we put our floor plan in as our exam require...
Hello, On a 7606 I have a broken WS-X6708-10GE that needs to be replaced. I don't see much documentation if the blades can be hot swapped. If I can hot swap, are there any commands to shutdown the broken blade first? And power it back on? What happen...
