This document provides information on how to disable any audio/video/data protocols on the C-Series, EX-series and E20 Endpoints.
Configure the endpoint to communicate using specific audio, video and data protocols in both SIP and H.323 calls.
Any audio/video/data protocols can be disabled on the C-series, EX-series and E20 endpoints through the use of the capset filter functionality. This is available through the GUI, web interface or API and can be used to remove any and all protocols you don't need for communications.
Here are some quick examples:
force G.722.1 -> disable all other: xConfiguration Experimental CapsetFilter: "AAC-LD;G.722;G.711a;G.711mu;G.729AB;G.729;G.729A"
Hello all,I am currently running into the issue where the web portal for our CUCM Voicemail can't be reached. I can still ping it, access my voicemail boxes, and so on. I just can't get to the GUI. I tried following this article by cisco but the heal...
I am running Call Manager 11.5 with two CUBES into the telecoms network. When I try to call a certain company that also uses the same Telecom I get a 404 recording from call manager. I ran a debug with the Telecom provider and they saw that we are strippi...
I have configured a b2b redundancy between two vCUBES (csr1000v 9.16.12.05). Group status is fine, active and standby status of each of the peers is ok. When active router is rebooted, standby takes over. However, call preservation does not work. T...
I have an issue where 1 user on my system is not getting MWI when they get a voicemail. I have tried to delete and re add the mailbox and I have replaced the phone with a new one. I also ran "Synchronize All MWIs on This Phone System" on the C...