Controllers

Hi,We got new devices for testing and now I'm trying to test provisioning. Officially this model is not supported, at least when you are adding new device you can't choose  product id (C1117-4PM) from the list in APIC-EM.The problem is :Due to advanc...

I have read the acitoolkit documentation at http://acitoolkit.readthedocs.io/en/latest/ but unfortunately I couldn't find any information regarding creating a Virtual PortChannel.Suggestions / tips are highly appreciated. Thanks!

Hi,we have different roles for different site/group admins and observers.one was responsible for setting up a good looking and structured topolgy view for all discovered devices on our biggest site. That took him a whole day to complete as a lot of d...

Hi there!What is the best way to export the CN=sdn-network-infra-ca certificate from the APIC-EM?Thanks,Thomas

Hello Fellow Networkers,In my current configuration a 2K/3K switch obtains a DHCP address across the pnp controlled native VLAN 666.  The adjacent sub-interface on the directly attached ISR is configured with “encapsulation native vlan 666”.  Plug an...

I have APIC-EM installed and use it to configure routers and switches.  We use 1921s, 3750Xs, and 2960Ss. (I know, old and outdated but that's what I have to work with for now.)  I connect the switches to the management port in my office to configure...

Hello! Please, help!I want to use the zero touch setting without Prime. There is no way to use DHCP or DNS parameters. In the APIC-EM, the manual switch did not add.I maked the settings on the switch manually:pnp profile network-pnp     transport htt...

HiI'd like to know about limit of UUID digits.I sometimes find below response."detail:2ace3214-4741-4432-8ab7-2068edc2bec54 does not conform to expected UUID pattern"Is there any rules of UUID?

HiI'd like to know about limit of UUID

Hi,We are trying out CIscoPnP and it works "most of the time."But sometimes we get 'PnP Service Error 1404' on a few devices. From what I have seen so far we can get it on 48 port switches like WS-C2960X-48xxx.I can take one switch and run it and it ...

Hellow Fellow Networkers,Configuration of APIC-EM requires that the first cluster member communicates with a test Cisco telemetry server whose hostname and IP address have changed since the software was published.  Cisco TAC recommends to raise a Ser...

Hi, Last December I heard that Cisco is going to release APIC-EM with PnP module only, is there any update on that?as an extra, is there going to be any support for ASR900, 920 and ME1200?