WAP150 radio configuration - weired behaviour

[BrightSami]

Good morning,
I am writing to you to find out if you have encountered the same bizarre behavior of my WAP150 wifi access point.
I purchased this access point for a small business; the speed that arrives at the box is around 700Mb/s. I configured this AP with 2 SSIDs (on 2 different VLANs) and activated the 2 radios 2.4 and 5 GHz.
At the 5GHz radio level (Basic Settings), I selected:
- Wireless Network Mode: 802.11n/ac
- Wireless Band Selection: 20/40 MHz
- Primary Channel: Lower
- Channel: 36
- Scheduler: None

In terms of advanced settings, I haven't changed anything.

On my computer, I forced my wifi card to connect to the 5GHz radio (it's a latest generation card that can go up to 802.11ax).

When I connect, I ALWAYS see that the protocol used is 802.11a with a maximum rate of 54Mbps

I tried everything but nothing changes. Do you have an idea on a parameter that I did not configure correctly please?

Thanks in advance

[Flavio Miranda]

Hi

 Assuming you clients is fine and suports it, change the channel to 80Mhz and test.

[BrightSami]

Hi Flavio,

Thanks for your help

Unfortunately, changing the channel did not improve throughput. The access point always "forces" me to connect in 802.11a in 5Ghz and 802.11g in 2.4Ghz