AnyConnect AMP enabler profile on FTD

[FirewallZia]

Hello - I'm trying to find out if AMP enabler profile for AnyConnect is supported on FTD, similar to how it is being done on ASA as explained below?

https://www.cisco.com/c/en/us/support/docs/security/advanced-malware-protection-endpoints/200284-Installation-and-Configuration-of-AMP-Mo.html

[Rob Ingram]

Hi,
No you cannot use FTD with the AMP enabler like you can with ASA. I believe it's in development, not sure when it's coming though. You should use your network management solution such as SCCM to deploy AMP4E.

HTH

[FirewallZia]

Thank you. I figured as much but wanted to confirm. Will resort to some other method for now.

[Marvin Rhoads]

We hope to the the AMP enabler (and other AnyConnect module support) in Firepower 6.7, projected release in for Fall 2020.

[Faran Mustafa]

does cisco FTD version 6.7 support amp enabler profile for Anyconnect?

[Marvin Rhoads]

Yes - since FMC 6.7.

https://www.cisco.com/c/en/us/td/docs/security/firepower/670/configuration/guide/fpmc-config-guide-v67/reusable_objects.html#id_42855