Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi, It's Hyeonjin Today my customer ask about CUBE session. We've 10 session license in CUBE. If that session(SIP Trunk) is full, I think ucm make busy tone. So, I want modify busy tone to other media. Is it availiable? If it is availiable, which m...
Do I need separate licence to Record Calls with Verint??
Hello, I would like help to modify one DID of my current configuration, I'm not familiar with IOS and I'm not sure what are the commands to do this. How can change the number 14401234567 for Any number? sh run.......................................
Hi All, I have one wired issue in my Cisco environment and that too only 2 users are facing that issue both are critical users. Let me explain the issue. These 2 users are not able to access their voice mail in their own device(Cisco IP Phone) but ...
I have a few users who are having their voicemail delete on its own. A voicemail is left and the MWI light will turn on and an email will come to the users inbox. After roughly a minute or so, the MWI light will turn off and the email will be per...
Hi, I have an MGCP QSIG E1 connection to a Nortel PBX which is in turn connected to the PSTN. For inbound PSTN calls route through the Nortel which is in turn sending the CLI to MGCP gateway with no leading area code but it is sending in with ISDN t...
Hey guys, I have a bunch of 8841 phones that work without an issue when I add them to recipient groups in InformaCast, however the 3905 model phones do not receive the page and do not go on speaker+mute like all other phones. I see it's supported: ht...
hi, All Can ASR5400 support SIP info and auto ? tks
Hi All,I did a no MGCP on a 3725 and its been about half an hour. When I go back and do mcgp it saysr-fwvpn02-il#conf tEnter configuration commands, one per line. End with CNTL/Z.r-fwvpn02-il(config)#mgcp%MGCP-SHUTTING-DOWN, Cannot restart...
Hello Music on hold is not working in intercom on subscriber server as its working fine with publisher. will appreciate if anyone help me out of this.
Good morning All, i have the following phones supported by CME 10.0 and i have been on a research for 1 year now looking for a way around getting the time display by the Cisco IP Phones sync with west africa time-zone, but no success yet. These are t...
Hi In our project we use CIPC for Incoming calls and we don’t want a “new call” Softkey as sometimes agent is pressing this key and due to this no call is reaching to him. We are unable to remove this key as it is stating that “Mandatory Softkey -- N...
Team, Please let me know how can we check how many users are supported in OVA template thats there in UCS server for CUCM ? is there any indication in ova template that talks about users limit as i dont have UCS Specification with me Regards Sabi...
Dears, i have a cluster of publisher and subscriber 10.5.1, publisher is crashed and i have no backup of publisher and now the organization is working on subscriber, i want to build the publisher up again how i can ?? i was following the below link b...
Has anyone here on the forums ever seen these errors? I have been trying to pull them apart and not really getting anywhere with my google searches. If anyone has insight to what these messages please share. I am new to the cube router and it is se...
