Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello, There is a timer of how much a call is on hold at CME (Telephony Service/Voice Register Pool)? Regards Leonardo Santana
Dear All, I am facing an issue on LDAP user authentication. I have cucm 9.1.2. I have configure LDAP synchronization correctly with AD using an AD account with read privileges on the user ou. It works fine, I see active LDAP synchronized users in "...
Hi All, My question is, how to full audio test, Cisco IP phones? Example 7942. I am use the POE switch, but dont like use the system. Test without phone registering. Thank you all answer. Tony
Hello good day dears please support me i have 7821 ip phone and its SIP phone and its not working with SRST in branch location . and as ber Cisco Compatibility Information can support from SRST v 8.6 and i'm already upgrade my routers IOS to 15.0 to...
Dear Sir, We have two Sites .example site A and Site B.call manager Bussiness Edition 6000 is placed in site-A and Site-B phones are registered on this BE 6000 through VPN.In Site-B there is a SRST Router for the redundancy In site-B there is cisc...
Hello, I have a cisco 7931 IP phone connected/registered to a CME. CME has a SIP trunk to a third party voice provider and the negotiated codec on the SIP trunk is configured to be ILBC. The SIP trunk seems to be working fine with the ilbc codec, how...
Hi, I used call manager express 10.5. I want outgoing call to PSTN via FXO port but SIP 486 Busy Here. Config and debug attached. Incoming calls working not problem but outgoing call not working. Example call: 1214 local sip phone (9)0506132XXX...
I have a really strange issue. I have two subscribers that cannot call devices registered on each other. They can call devices registered on other subscribers, and other subscribers can call them. They just can't call each other. When attempting to c...
Ok, I'll start with the longer version of the story. After using a Sennheiser wired headset for years, I decide to upgrade to a wireless version. I chose the Sennheiser DW10 model, with the Sennheiser lifter.You can find the discussion on that here:...
Hi All, What is the interest of phone licenses? can i use just CME license without Phone licenses? Thanks, Ragards MM
I have Cisco IP phone 7912 series and the ringer volume is not working. When I press the volume button, a red light on the handset blinks but I am unable to hear any ring. Also i tried Menu -> Settings -> Ring Type . Selected a ring type and pressed ...
Hello! is it possible this operation? i have a router c3925 with ios c3900-universalk9-mz.SPA.152-4.m4.bin , cme 9.1.
Hi all, we have a CUCM v.7.1.3 and some gateway VG224 with IOS Software-12.4.2T6. we need to upgraded to VG224 to version 15.1(4) MD10. Question: VG224 with IOS 15.1(4) MD1 is still compatible with cucm 7.1.3 ? We are doing a high level design for...
Hi there, campus user has a windows laptop, everytime user goes home, in jabber the phone control feature switches to use my computer but when at campus, it does not switch back to use my phone it's still defaulted to use my computer. any ideas to w...
Hi! I have the following situation: the customer administers his PBX for himself and sends calls to the PSTN over our CUBE. I would like to overwrite the calling number if this number does not belong to the customer or if no calling number will be s...
