Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi all,Is any command to simulate a voice call on the router ?Thanks.
Users connect to the conference - about 45 participants. When I see all participants - 45 constant in RTMT all participants continue to hear sound like somebody whant to connect to the conference?What can it be ?? I think it can be a problem of some ...
HiI am trying to set a Recovery Period for Deleted Voicemail as per the below document:http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_configuration_example09186a008060d71e.shtmlI would just like to know is there any way to recover the...
Hi,I configured conference at ccm 7.0, but when i try to make a conference with an analog phone (ericsson pabx) it din't work. I saw at DSP calculator and the number os DSP is not the problem. I have to configure something in the router?When i tried ...
Hello, i have a CME, the router has 4 FXO ports,each port connect to the PSTN they are under a common trunk group called BRC, when i make an outgoing call the call takes the first port, but if i disconnect the line from the first fxo port the call c...
I need to build a UC500 based system with a lot (almost 20) of analog ports for physical FAX machines. It seems like the most I can do on the box itself is 4 FXS ports therefore I am looking at ATA devices. I have several questions concerning this:...
We implemented tam-b at many locations and there is one particular location that the tab-b picks up, but it doesn't pick up fast enough. Takes about 3-4 rings. Is there a way to make the ring pick up faster then that. I was told to increase the ring ...
Can anyone tell me how this phone type is added in CUCM 6? I'm assuming that it is added to the system as a 7921, correct?
Has anyone implemented this with jtapi and sip as outlined in the doci? Anyone have configuration example
Hi,Does anybody knows if I can configure a callmanager 4.1 to display an special caller id name when I receive a PSTN call?Thanks
Are there any steps if CUCM system begin working bad or not loading? What should I do first? Is there ay restore CD in this case that I can use with backup to restore needed information?
we have an issue with SNR where there is no ringback when the Remote Destination (cell phone) is ringing. Once the call connects, the audio is fine. The cell phone rings, but the caller does not hear ringback.Here is the call flow:PSTN --> CMM (H32...
I am trying to bring up 3 pri's (new install) and I am receiving this when I debug "isdn q921" *Feb 11 14:17:24 MST: ISDN Se0/0/0:23 Q921: S4_SABME: BACKHAULED & vsc_wants_L2_up = FALSEIDEAS? I have verified pri switch type
Hello Folks,I have two issues with my VG-248.First issue:I make a call through the VG and the called party hears the ring and answers. Everything works fine, except when the called party hangs up before me, I start hearing a fastbusy tone. As soon as...
Event Type: ErrorEvent Source: Cisco CallManagerEvent Category: NoneEvent ID: 3Date: 2/11/2009Time: 8:10:44 AMUser: N/AComputer: call managerDescription:Error: DeviceTransientConnection - Transient connection attempt. Connecting Port: 2000 Devic...
