I see a lot of information on Click to Call through the years. I am confused at what actually has to happen to get this to work. We do have the Web Dialer service, as well as CTI enabled and configured. Through no additional work I can click a fellow...
Forum Posts
On my 8851 when selecting Modify Button Items on the Device page - I show this:I'm trying to have the first SD, 68916 appear on the top right key (#6). Instead, I show a handset icon. If I press that, I get dial tone. Another 8851 template doesn't ha...
When selecting the voicemail key on a 9841 with a 2nd line, I must then select which line is to be used to access voicemail. At that point speakerphone mode is activated and I'm prompted to enter my PIN. If I remove the 2nd line and press the voicema...
Hi ,I have a Cisco 8865 phone with PID cp-8865-K9=V03. This device is currently running on Firmware version sip8845_65.14-3-1-0001-60. I am trying to access the 3PCC Web Configuration utility to change the provisioning server. We are still running on...
We have two sites, A and B. Now the phone at site A can call the phone at site B, but the phone at site B cannot call the phone at site A. When the phone at site B calls site A, the phone keeps beeping, as if the line is busy. Can you help me analyze...
is there a template of the .cfg file that i need to add in the pattern maps? i know the commands to have it referenced. but not really sure if there is a certain format to that is needed. Any help would be appreciated. voice class e164-pattern-map...
Resolved! Unity connection license issue
Hello everyone, I have an issue with one of my Unity Connection. It recently saw that it was never properly activated. It was not a problem because it works anyway but yesterday I had to change something into the user options. You should know that ch...
Hello Folks,I have a quite confusion over here. We are running CUCM 8.5. We want know the exact procedure to enable SSH login on cisco ip phone.Your answer is much appreciated.Kulasekara Raja. K
Fire voice call to monitor your critical number from Cisco voice getaway Cisco IP SLA VoIP Call Setup Monitoring story In the process of building a lightweight SIP call monitoring solution, I initially tested tools like SIPp and Python-based scripts...
Has anyone ran into the precop check for Source release only has swap space of 2 GB, which is not enough for destination release 15. We are running running 110 Disk CM 12.5 and our precheck is getting this. Should we try to upgrade and see what hap...
Hello there!In our CUCM setup (v15), the design choice for security reasons was to disable setting access via an IP Phone. So every setting needs to be pre-configured by the administrators (my team) via the enterprise phone configuration and common p...
Hello. I've spent a day or three trying to understand the NS OCI schema files and online Cisco OCI-P documentation. I'm able to get an NS system user logged in using OCI-P via the XSP server to the Network Server, but I am not able to form an accepta...
Hello All,We had a power outage and when power was restored this particular cisco phone didn't come up. I shut no shut interface it was connected to nothing. I then plugged the phone into different stack to test and it came up. Went back to previo...
Hello everyone,We have a SIP trunk between CUCM 11.5 and 3CX 20When making calls from 3CX to Cisco, Name and Number is visible on Cisco phone. But when making calls from Cisco to 3CX, only number is presented.I am looking at the logs on 3CX side, see...
Hello, I have a question regarding the box2box Cube HA. Our customer has a B2b configuration where each cube is connected to one switch on each end and there is direct connection between the cubes via Gigabit Port. The customer has tried to do a ...
