Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Is there a way to find the difference between various CPNs for Cisco 7841? Is there any tool showing Product Numbers, Cisco Part Numbers, and their descriptions?I want to find the exact meaning of 74-10232-01. Is it related to region, version, or rel...
Hello everyone, trying to set up SRST for Jabber with ISR 4331 routers, but haven't managed so far to find documents where this is explained in details. Some information was found here below, but except for some posts on the Community seems that no c...
this issue was fixed with new release firmware PHONEOS-8875.3-2-1-0003-28
My company is looking for a visible flasher for when a phone call comes through due to the volume of the environment. I know that there are some options through AlgoSolutions and Cyberdata but those are very expensive. I'm wondering if a product li...
Security hotline team has group of phones with shared line for hotline calls. Would like every call prefixed with "Your call may be recorded for quality assurance purposes". Preferably within the call (to capture in recording) but before the call is ...
Hello all, I'm using Hunt Pilot to use common voicemail in CUCM12.5.I want to use the External Call Control Profile, but found that it is not available on the Hunt Pilot.Is there any alternative? Thanks in advance.
We have a user (A) that took over the position of another (B). User A, has two extensions on one phone. On all incoming calls to the phone, there is a message that displays the old user (B). The mess is "Incoming on User B." I've look in call manag...
Hi,I have just recently bought (thanks to recommendation from @ vishalbhandari) Cisco 6841 for my project. It is a test unit. I want to configure it so that it receives Network policy (vlan, pcp, dscp) via LLDP-MED. The switch to which it is connecte...
Hello everyone!I recently have gotten a Cisco CP7925G Wireless Ip Phone to connect to my Cisco UC520.I am aware that both products are out of support, but my UC520 works just fine.I need help, and I need the USB driver for the CP7925 to configure it ...
Hi All, I need support in finalizing the BOQ for 8300 series router, we will need 50 SIP trunk license, which we added in A-Flex sku. As the new 8000 series have universal image, do we need to add separate PVDM for SIP trunks or fxo cards as it came ...
Hello, I am intrigued by the 'can it run Doom' community and all of the one off devices it has been installed on. I recently got an 8841 and was curious about anyone else's experience with trying this sort of thing. I have no idea if it will work or...
Hi, I am having an issue when some users try to change their PIN, they get the following error: Error: [2755] ADMIN_ERROR_NO_UDT_IN_USER_PROFILE The CUCM version: 14.0.1.13900-155 Any ideas? Regards, Uros Kovacevic.
Is it possible to mark the phone/line as busy for BLF even when the phone/line is not in use?
HiI have Cisco Call Manager v12.5 and have set the Busy Trigger to 2. In this setup, if someone tries to call me while I’m on another call, they aren’t notified that I’m busy. Is there an option to either notify the caller that I’m on another call, o...
Hello, I have a customer with CUCM 14SU1. They have recently purchased a VG410 which has 48 FXS ports which connect analog phones at one of their sites. The VG410 is not supported as an SCCP gateway until CUCM 14SU3 so I have set it up with dial peer...
