H.323 Gateway config for FXS

[wmelick]

I think this is a fairly basic question, but I am trying to send outbound fax calls from an FXS port to a PRI on a Cisco router (configured as H.323).  

I have the inbound config OK (assign the FXS voice port an internal station ID, setup an inbound translation rule changing the DID to the station ID, setup a dial peer destination pattern matching the station ID and set it to the  FXS port).

How do I do the inverse to get the FXS port to route out the PRI using an H.323 config?

Thanks

[MOHIT SINGH]

You can just create another POTS dial peer with destination pattern .T and PRI port to send out calls through PRI.