Special tone remains although CMC and FAC (forced auth) requirements are not enabled

[CHRIS HUFF]

I have a situation where I do not have require CMC or Forced Authorization Code enabled in any patterns, but if I dial a # that matches the LD pattern it still gives a special tone. At that point any 4-digit number can be entered and the call is made, as if CMC was set as required.

I've verified no additional filters or patterns match the #'s I'm testing. I've verified 100 times that CMC and FAC "require" boxes are not checked.

I'm on 10.5 currently.

Is there a place I have forgotten or cannot find in the AD manual where a CMC requirement can be set globally or for a an entire partition/call search?

Can't figure out what I'm missing here..

[Jaime Valencia]

No, FAC and CMC can only be enabled at the RP level, are you sure what you're hearing is not actually the secondary dial tone??