Hello,
I am needing assistance completing a MAP-T configuration on a CSR1000v router in GNS3.
I am using Kea as my DHCPv6 server and my CE router is getting an IPv6 address and an IPv6 delegated prefix.
Everything on the CE router and host Ubuntu workstation looks correct, but when I try to ping 8.8.8.8 I get no response.
A packet capture shows "Destination Unreachable", see attached PNG.
Below is my routers config and CE router/host IPv6 information.
CSR1000V - Cisco IOS XE Software, Version 17.03.02
ipv6 unicast-routing
!
interface GigabitEthernet3
description IPv6 network
no ip address
negotiation auto
nat64 enable
ipv6 address 2001:DB8:1::1/64
ipv6 enable
no mop enabled
no mop sysid
!
nat64 map-t domain 1
default-mapping-rule 2001:DB8:1::/64
basic-mapping-rule
ipv6-prefix 2001:DB8:6::/56
ipv4-prefix 96.46.113.48/29
port-parameters share-ratio 32 start-port 16384
CE MAC: 84:d3:43:a5:62:60
CE IPv6: 2001:db8:1:0:86d3:43ff:fea5:6260
Host IPv4: 192.168.1.216
Host IPv6: 2001:db8:6:2:ee6:22ef:73fd:5dbd
What am I missing in my configuration?
Thank you,
Heath Urbanczyk
