MPLS and bridging over FR

[liviu.gheorghe]

Has anyone seen this message:

The bridge-group command is unsupported on the interface:Serial2/0:0.24

when the MPLS feature has been enabled on

the main interface or one of its subinterfaces:Serial2/0:0.2

It used to work in 12.2, but after upgrade to 12.3.5b it's not.

I didn't find anything in the documentation about this problem.

Any help is appreciated.

[Harold Ritter · Accepted solution]

The combination of these two features is unsupported and has caused problems in the past. A check has been implemented by CSCdz75507, which will prevent the configuration of "bridge-group" if MPLS is configured or vice versa.

Hope this helps,