Cisco ISE terminal length/page 0 equivalent

[atsukane]

Hi there,

Apologies for a primitive question here, but is there a CLI command equivalent to "terminal length 0" or "terminal page 0" on Cisco ISE?

I did see "terminal length" command under DO section on the Cisco documentation, however, upon issuing it on the ISE node it does not accept it.

Thanks in advance.

[Aref Alsouqi · Accepted solution]

What version of ISE you are on? I think starting from 3.2 the new command is "screen-length".

[atsukane]

Hi @Aref Alsouqi , our one is v3.2 and "screen-length" did the trick!

Thanks very much!

[Aref Alsouqi]

You're very welcome.

[Aref Alsouqi]

Please take a look at this link that has some useful information about some changes on ISE 3.2 CLI:

Cisco Identity Services Engine CLI Reference Guide, Release 3.2 - New and Changed Information [Cisco Identity Services Engine] - Cisco

[atsukane]

thanks, that's very helpful

[Aref Alsouqi]

You're welcome and glad I could help.