Hello Cisco Prime experts,after upgrade to V3.10.4 Update 02 our licensing connection to our internal Smart Software licensing Server is broken.All licenses are shown in evaluation mode!Release Notes state the following:Starting from Prime Infrastruc...
Forum Posts
I will like someone to share with me how to change the port speed on an IE-1000 using the web GUI. I will like to know if this is possible since I don't see it anywhere on the product specs on how to do it.
Resolved! Cisco prime GUI is not loading .
Recently we built new prime and its running with 3.1 version. Through CLI we can able to access but GUI (web page ) is not loading. Version : 3.1.0Build : 3.1.0.0.132 ncs status output: ------------ Health Monitor Server is running. ( [Role] ...
Has anyone configured Cisco EPNM with Microsoft NPS server, will not authenticate have added all the cisco-av pair attributes. works fine with all Cisco Routers / switches
Hi,I have been having some issues lately with trying to allow certain devices to connect to multiple networks via mac filtering.The problem I have is that if I assign a device a WLAN profile it only allows me to connect to the one network that profil...
Hi All. I have a simple topology with three routers connected by serial interfaces with loopback interfaces and two switches connected by Gigabit interfaces , I have the option to modify the hello and hold timers , in a production network what value ...
Hi,when I connect a PC to my corporate network with a static IP 192.168.x.x without correct DNS (subnet not present in the network) a sort of broadcast storm occurs that creates a network block and related packet loss.The switches seem to no longer r...
Hi I am learning about advanced EIGRP and have made the following notes for advanced features that can be implemented , would somebody kindly pass comment on if I have missed anything or if theres any other advanced features I can configure as part o...
Hello everyone,I need to query the AP9120 via SNMP to retrieve the device name. We are using a Linux server located in a different subnet for the query.The WLC is a 9800 model with SNMP enabled. When I query the WLC, it responds with its name, but wh...
Hello,Anyone know which ios minimum version to create EEM script?I can see in this article Cisco IOS Embedded Event Manager Command Reference - E through event manager Commands [Support] - Cisco the minimum version is 12.2I have C2960X running versio...
Resolved! asa 5515 ios image deleted
I deleted all disk in ASA 5515 so I lost my IOS image unfraternally I can't get the ROMMON. the system gets this message> " Password recovery and ROMMON command line access has beendisabled by your security policy. Choosing YES below will cause ALLco...
I'm looking to create a very basic EEM script and I'm having problems with it. This is my first stab at trying to right my own. The objective is that after a device passes its authorization run a command and display that result in a syslog message. ...
Hi, I'm currently trying to make a CISCO_ASR1002:Cisco IOS XE Software, Version 03.16.06.S - Extended Support VersionCisco IOS Software, ASR1000 Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version 15.5 (3) S6, LAUNCH SOFTWARE (fc3)Send CGNAT transla...
Hi all!I am trying to configure a collapsed layer network architecture. I configured HSRP and L3 switches sees each other with no problem (sh standby br is OK) but when I configure a PC in VLAN10 and give default gateway as the HSRP virtual IP to it,...
I have a problem with NX-OS and i am trying to initiate the following command to filter output of "show cdp nei det"this is how i would done on 6500show cdp nei det | grep Device |IPv4 Add|Cisco IOS SoftwI need this to work on NX-OS.. I noticed lots ...
