some times i see some challanges on EEM Script like the one you looking.
i would use out of the box Python script for this kind of task (Hope this is one time).
you can use example :
from netmiko import ConnectHandler
from textfsm import TextFSM
from netmiko.ssh_exception import NetMikoTimeoutException
from paramiko.ssh_exception import SSHException
from netmiko.ssh_exception import AuthenticationException
with open ('devices.txt') as routers:
for IP in routers:
Router = {
'device_type': 'cisco_ios',
'ip' : IP,
'username': 'user',
'password': 'passwprd'
}
try:
net_connect = ConnectHandler(**Router)
except (NetMikoTimeoutException):
print ('Timeout to device' + IP)
continue
netconnect = ConnectHandler(**Router)
print('-'*79)
output = netconnect.send_command('show int status',use_textfsm=True)
for i in output:
if i["vlan"] == "1" and i["status"] == "connected":
config_set = ['interface ' + i["port"], 'shutdown']
x = netconnect.send_config_set(config_set)
print(output)
print()
print('-'*79)
netconnect.disconnect()
