Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello    I want to create an access control list on a router that does the following:   1) access control list to deny all inbound traffic with network addresses matching internal-registered IP address 2) Deny all ICMP echo request traffic  3) Deny a...

I am aware of the 10m cap on Virtual FMC database.  I have seen options for external database connections.  Am I misunderstanding this or is it possible to create some sort of SQL database on a server and give FMC access to utilize that database thus...

Will by Level 1
  • 5359 Views
  • 8 replies
  • 0 Helpful votes

Hey guys,   I recentlly purchased 2 ASA 5506-X to replace Meraki MX50 appliances and I'm running into an issue. Basically UDP traffic including port 67 is being discarded inter VLAN   My configuration: ASA-tunk port-SWITCH-trunk port-WLC             ...

iancuv001 by Level 1
  • 665 Views
  • 4 replies
  • 0 Helpful votes

I am trying to figure out the IP addresses required for Firepower 4100 series bundle and FMC mgmt setup.  Here is what I have figured out so far: - One IP address for each Firepower chassis (managed through either firepower chassis manager FCM GUI or...

S891 by Level 2
  • 633 Views
  • 1 replies
  • 0 Helpful votes

I have two zones in firewall Zone-1 and Zone-2. One Server is connected in Zone-1 192.168.1.15. Two desktop are connected in Zone-2 with different subnet/vlan (Desktop-1 10.14.3.150/24 and Desktop-2 20.14.3.150). Both Desktop are able to reach the Se...

Hello All,   I am very new in using the CISCO ASA. I've watched tons of videos already but my brain freezes for some reason. I bought this firewall and can't configured it properly, can someone help me please. I am trying to learn how to allow any ho...

Hi All,    I'm trying to set up SNMPv3 on one of my production ASA 5525-Xs. From what I'm seeing, the ASA is never responding to the SNMP GET requests being sent from my NMS. I've also tried configuring SNMPv2c and have gotten the same result.    I a...

Hi All,   I have an ASA5510 running IOS 8.2. I want to experiment with allowing a server on our network to SMTP to our Office 365 exchange service. I have configured the access list on the inside interface to allow our server to telnet out on port 25...