Network Security

I have two interfaces on Defense Center.  One of them (eth1) is on a management vlan that does not have Internet access.  When AMP tries to connect to cloud it frequently tries via eth1 and I get the above message and a health monitoring alert.  I kn...

All, What is the command to change the IP of the firepower Module after the initial install. I need to be able to chnge the IP of the builtin Mod on the 5516X. I having hardtime finding the command. Thanks

Hì, we are evaluate this ASA model: ASA5508-FPWR-BUN. We need a device with integrated FirePower services, for a small network without any server installed. Or possiblity of install any type of hardware different by network device type. This model ...

The subject line also appears when I have no SSL policy and I directed the traffic to the SFR module.  New install. Looks like any outbound traffic from the inside destined port 443.

Hello, I am attempting to upgrade my VM sensors from 5.2  to 5.3.0 however I am getting the below error message on the DC. error running script 000_start/111_FS_integrity_check.sh Can anyone assist.

Hello,  As you can see in my topology (attached below), the main idea of my project is to connect two remote network through WAN with an IPSec/GRE tunnel and to let one PC (PC3), from the network on the left, access the Internet or the other network ...

how to get bandwidth Monitoring access from asa Firewall 5512.Kindly help  me with that concept. I can check the top 10 users who are using bandwidth but not managed 

I'm running ios ips on a c3825 isr.  We were having multiple instances of intermittent latency and poor wan performance.  I disabled and retired all signatures from basic category except a handful.  I noticed there was still poor performance.  I then...

Hi I am trying to create a simple access-list rule that restrict an external subnet to ping to any host behind the firewall. The rule is access-list outside-access_in permit icmp host 172.2.1.2 any The rule loads without no issues. But, the external ...

Hello, I am trying to build a custom report to view the number of users in a specific subnet (example, 192.168.10.0/24) who were online in the last 24 hours. I do not know if it is also possible to see how many users in this subnet were online simul...

Dears, we have purchased ASA 5525X with firepower, i m running 8.2 on my old asa i want to migrate the configuration, i am using the below link tool for the migration but it is not doing properly, https://software.cisco.com/download/release.html?mdfi...

Dears when I migrated to 9.5 all my access-list are showing me like host ::  , but in startup config I can see the IP address.any ideas please. access-list DMZ extended permit tcp host :: host :: eq www. Thanks