Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more

Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Cisco CyberSecurity
Labels

Forum Posts

Start a conversation

OSPF Firepower device manager

Hi Experts,   I am attempting to setup the following on an Firepower managed by FDM. All the OSPF settings have been replicated except "redistribute static subnets". I've tried and observed that after enabling only "redistribute static subnets" and s...

Arun2022 by • Level 1
  • 709 Views
  • 4 replies
  • 0 Helpful votes

Firepower IPS hdd replacement?

Hi, In an emergency situation where a firepower device has a corrupted drive. Is it possible to use a physically compatible drive as a replacement instead of ordering a direct replacement from Cisco or vendors? Thank you.

KGrev by • Level 4
  • 408 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Anyconnect Plus licenses

I have purchased Anyconnect Plus licensing on behalf of customer for upcoming firepower project for FTD 1010's. I didn't really think it through until now but I have 4 FTD 1010's and I am wondering is if users at these tail sites will be able to use ...

Monitoring OpenDNS VA with SNMP & Solarwinds

Hello,I'm having an issue getting SNMP setup properly on my OpenDNS VA. I have followed the steps outlined in the documentation below:SNMP Monitoring (umbrella.com)However, neither version 2 or version 3 allows me to connect with the VA when performi...

ewmoore by • Level 1
  • 744 Views
  • 0 replies
  • 0 Helpful votes

Cisco ASA SNMP management interface error

Currently I have two Firepower 4112s that are both running ASA software, these two ASAs are setup for HA and both are in single context mode. I've managed to successfully enable SNMP polls and traps on the primary ASA using the dedicated management i...

BVC by • Level 1
  • 988 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Site to site VPN port 4500

Hello,I have a site to site vpn between two Cisco 2811 routers passing through a PIX 515 on the core side and an ASA5510 on the remote side. Although I have ports ESP and ISAKMP open the tunnel also requires udp port 4500. Is that normal? If not any ...

Resolved! Anyconnect - setup remove old protocols

Hi all Setting up Anyconnect from scratch on the firepowers. Using the FMC. How do i remove the old protocols like TLS1.0 and TLS 1.1 from being used. I cant see that in the anyconnect setup ?Is this done at the interface level ? Any help would be gr...

old roo by • Level 1
  • 766 Views
  • 6 replies
  • 5 Helpful votes
View All
Review Cisco Networking for a $25 gift card