12-05-2019 09:45 PM - edited 02-21-2020 09:44 AM
Dear All,
We have some requirement related to cisco FTD form FDM.
What I need in configuration ?
There is a Cisco Core switch installed in same DC which is configured as Layer 2, one separate L3 VLAN needs to be created which will be forwarding all the traffic of that VLAN to this firewall.
Enable NAT
We have 4 internet links, need to enable load balancing and auto failover
Configuring 3 servers in DMZ zone of Firewall (PAT is required)
how can we configure load balancing form FDM although it not support PBR
or how can we configure dual static route on FTD via FDM because it is not allowing us to configure this?
12-05-2019 11:44 PM
Hi there! I am a bit confused by the title of your question which includes " Dual ISE" but no mentioning of ISE in the actual question so I am guessing you meant "Dual ISP? :)
Now to answer your question, you can configure PBR with the help of FlexConfig:
https://www.youtube.com/watch?v=lakHhw9CR5Y
Thank you for rating helpful posts!
12-06-2019 01:14 AM
Yes it is ISP have you read my full message i have mentiond via FDM not FMC.
12-06-2019 06:51 PM
Yes, I read the entire thread and my answer still stands as FlexConfig is supported in both FMC and FDM. You can use the youtube video as a reference.
Thank you for rating helpful posts!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide