How to access firepower through outside interface using ASDM

[wael Kamal]

Dear experts,

I have ASA 5506X  and I configure the ip address of firepower module and inside in the same subnet and i can access it using ASDM but from inside but from outside the ASDM  give me i can't access ip address of firepower doesn't show firepower tab  

[Jetsy Mathew · Accepted solution]

Hello Kamal,

First of all confirm that you have followed any of the following deployment method mentioned in the link.

http://www.cisco.com/c/en/us/support/docs/security/ips-sensor-software-version-71/113690-ips-config-mod-00.html   (also applicable for sfr)

Let me know which kind of deployment that you have from above link.

Kindly rate if the post helps you

Regards

Jetsy