cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1072
Views
0
Helpful
1
Replies

SGT Based ACP on FMC doesn't work static IP-SGT binding

Jay Tiwari
Cisco Employee
Cisco Employee

Hello Everyone,

Issue: SGT based ACP doesn't work for static IP-SGT.

Scenario: Have FTD managed by FMC (both version 6.4.0.4). FMC is integrated to ISE version 2.4 p11. After successful integration we can see SGT in FMC.

In ISE we have static IP-SGT binding and enabled SXP. Also enabled "Publish SXP binding on pxGrid" so that static IP-SGT binding can propagate over pxGrid. However we neither see SXP topic is subscribe over pxGrid connection not static IP-SGT binding in FTD.

Is this supported in FTD/FMC today?

Can we configure SXP between ISE and FTD?

 

1 Accepted Solution

Accepted Solutions

Hi,
I’m reasonably sure this functionality was only released in FMC/FTD 6.5, publishing static bindings via SXP is not supported on 6.4.

HTH

View solution in original post

1 Reply 1

Hi,
I’m reasonably sure this functionality was only released in FMC/FTD 6.5, publishing static bindings via SXP is not supported on 6.4.

HTH

Review Cisco Networking products for a $25 gift card