Many of the EEM applet actions set some built-in variable to indicate their success status or store some result data. Unfortunately, these variables are not well documented...until now. Below is a list of actions and the variables that they instantiate (along with a brief description of what each variable contains).
Stores the sum of the previous addition operation
Contains the output from the
CLI command executed. It will be overwritten each time "action cli" is invoked
Stores the current value of a counter after the inc, dec, set, or nop operation has been performed
Stores the quotient and remainder respectively of the previous division operation
If the handle-error action is "ignore" then any error will be stored in the $_error variable. This error will be a string value. A healthy result is always "FH_EOK".
Hi Guys, I have created a 3x VLANs on C3560. I have configured 'ip routing' and needed interfaces. I have access to the internet and I can try ping hosts in the other vlans, however I get response from them only if I add a route manually on each host...
Hello people, I have a pair of C9500-40X running SVL in a 24/7 environment. Once connecting a server using TWINAX cables didn't worked, there was no link on the ports. This was not the first server connected to the 9500s. Due to the urgency the serve...
Hi I am trying to send command show run for switch via ansible, but I got an error message as below. The commands I use is also listed as below. Not sure what is wrong with it. Thank you admin1@Lenovo10:~$ ansible lab-hosts -m raw -a "show run" -u ad...
Hi, I have two Room Kit Pro systems and a Crestron Control Unit. All in the same network connected via switch with DHCP. I had both systems on static IPs and everything worked fine. I could configure the system via webinterface and control per ...
So I know these are compatible but I need to know if the port configuration for these cables is on an individual basis or if they are grouped. In other words, can I use one breakout cable on port 3 and all other ports use 40G QSFP?