28855
Views
5
Helpful
0
Comments

Options
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
11-04-2009 06:26 AM - edited 03-01-2019 04:27 PM
This Reader Tip by Tahir Javed explains how to execute "show" commands in Global Configuration mode.
Just type "Do" in start of that privilege mode command and press Enter. It will display as it is output as you can see by executing it in enable privilege mode.
For example..
"router(config)#do show ip int brie"
Labels: