cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3934
Views
0
Helpful
3
Replies

GLC-LH-SM transceiver modules

I have an application where two C2960-24TC-L switches located 450m apart have to be connected via a 62.5 MM fibre link using the GLC-LH-SM transceiver modules. The fibre link is terminated to SC patch panels at both ends. The question is can off the shelf 62.5 MM LC-SC patch cords be used to connect the switches to the patch panels? If not please recommend a suitable patch cord, thank you.

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

Should be fine.

Tom Randstrom
VIP Alumni
VIP Alumni

It is recommended that you use  Mode Conditioning Patch Cabes for your application; model CAB-GELX-625= (or similar from another vendor).

The following documents outlines the implementation of these cables.

http://www.cisco.com/en/US/prod/collateral/modules/ps5455/product_bulletin_c25-530836.html

http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/installation/note/OL_19329.html

I hope this helps!

Thanks for the advice

Review Cisco Networking for a $25 gift card