Other Network Architecture Subjects

I have a simple set up. The gateway on our LAN is 10.0.0.1 I have a 1605r set up on this LAN with ethernet0 10.0.0.222/12ethernet1 is 192.168.0.1/24i have a pc connected to ethernet1 with ip address 192.168.0.2I made a static route on the routerip ro...

Is there a notice from cisco of problems with the 4500 power supplies? We've had 2 infant mortalities in 3 weeks, and Cisco seems to be out of spares.anyone else having difficulties we should know about?DanFrom: lmo-shortage-updates@cisco.com [mailt...

We have a number of Cisco 2940 switches - 12.1(22)EA4. They are connected by a dot1q trunk (in e1/0) to either a 2950 or a 4506 (both VTP clients). The management adddress is VLAN 400. VLAN 1 is shut down. Periodically the 2940 will drop off the netw...

Hello ,Customer has three buildings which are interconnected through ethernet. At main building we have a 6500 catalyst switch which interconnects to a 3500 catalyst switch at one building and to a 3750 catalyst switch to the other buidling. Is it po...

Hi, the router cant not boot normally. It give some error message. i change register to 0x2100 enter rommon, there are some crashfile stored in flash. how can i get those crash file from the router. (the router only work in rommon). thanks BRs

have a network 192.168.0.0/22. I need to break it up so that I can take the 3.x range to a colo. Problem is that network is flat, no trunking across 30+ switches.I am adding Trunked switches and will be moving people off the 192.168.0.0 /22 network ...

I applied a QoS Service policy to a VLAN interface of a 6500 MSFC. It does not appear to work because no traffic is being matched. Is it not possible to apply a Service Policy to a VLAN interface?

I have a Catalyst 3750G-24TS-24 switched with the enhanced image.One of the optical interfaces is connected to an uplink OC12 Mux. I would like to run 3 of its copper Gigabit interfaces at 200Mbps each.Is this possible? example, ideas, urls etc are w...

HI Guys,I wonder if anyone can help me. I am implementing a wireless lan in a public premises. however, i need only the residents to acces the WLAN.Can i implemnt a MAC address filter on a Catalyst to encompass all of the permited mac address and dro...

Is is possible to add a description to a static route on a router ?thanks

when i say no shut it gives me the folloving:Router(config)#int fa 0/0Router(config-if)#no shutRouter(config-if)#00:02:42: %AMDP2_FE-1-INITFAIL: CSR0=0x0000Anybody help me please?

hello. I have a problem with a cisco 2600 router. in that router I have two T1 internet conections. each connection in every serial port. well... the problem is..: when both conections are working at the same time my conection speed is 100 Kb/s!!when...

Hi, we have 3 switches (A,B y C), Switch A is conected to switch B and C.We have some QNX servers and clients conected to this switches, but some times the clients can't see the servers, o the clients can't see the others clients, this is just for fe...