Other Network Architecture Subjects

I am trying to implement 802.1X Port-Based Authentication with Cisco 3550 series switches. I am also using Cisco ACS server for authentication.1. What shoudl be the auth protocol between switch and AA server ( RADIUS or TACACSS ?).2. How does the mac...

My customer would like to do layer 3 routing on 3550-12G switch. The documentation only shows on IP routing but not on IPX. Does the box support IPX? From my understanding from the product info it does not support IPX but needs a better confirmation....

Hi all,I have IBM router with 2 ethernet connect to Cisco Catalyst 3550. 1 of the ethernet got block from the Catalyst. As I need 2 ethernet port to be active when connect to the Cisco Catalyst. How to do this.Thanks in advance.HATO

I think IGMP Snooping is a bit in-effecient,Correct me if I am wrong.I have a cat3550-24EMI I wanted to take adavantage of IGMP Snooping. I have a mrouter attached to f0/1 running PIM Dense mode and i have client on f/02. When I join a group 226.1.1...

hi All, I want to get Wrr configuration information on cisco catalyst 3550. For example: wrr-queue bandwidth 20 20 20 40 Which mib contains this information?Thanks

To any one in the Community,   Hello from an enthusiast & Network Administrator. I am currently working on a simulation for an Inter-Autonomous MPLS-VPN (ASBR1-AS#100 & ASBR2-AS#200) with the two VRFs, CE1A, CE2B(AS-100) & CE2A, CE1B(AS-200), CE1A&B ...

Team,Recently I participated to one of the Cisco partner briefing where they pitched iWAN design using internet as an alternate transport. With dual ISP connections, the increased SLA at reduced cost compare to MPLS. It leveraged DMVPN, WAAS, QoS, Pf...

We have one company which want to connect their BO to the HQ. Right now they have just Smoothwall firewall for HQ and there is nothing in BO. They want to make VPN between BO and HQ, to use just one gateway (firewall - maybe Smoothwall) from that net...

Hello,I have an access-list permitting only Radius traffic out the ethernet: access-list 101 permit udp any range 1024 49151 host 10.0.0.254 eq 1645access-list 101 permit udp any range 1024 49151 host 10.0.0.254 eq 1812interface FastEthernet0/0 ip ad...

Hello everybody,   my question is about how (peripheral) device drivers fit the OSI model. In particular:   I understand the meaning of all OSI layers when it comes to peer to peer communication (ler's say, PC to PC communication). However I get conf...

We have installed Cisco IE-2000-4TS-G-B switch for CCTV. We are using Axis CCTV PTZ Camera (AXIS P5635-E MK II 50 HZ). For powering CCTV we are using POE Injector ( AXIS T8134 60W MIDSPAN). But problem is whenever switch getting Hard rebooted switch...

Hi all,I need your help on setting up NTP on L2 Cat2950(standard image). There are 4 vlans with 4 diff ip/subnet on this switch with no default gateway.One of the vlan is connected to another switch, Cat3550.Im planning to set Cat2950 to get NTP time...

Spoiler   Which router model we have to use for configuring a cisco router as a tftp server  How to configure a cisco router as tftp server  How to  backup  current-configurations to tftp server