Other Network Architecture Subjects

I have a Cisco 837 10/100 ethernet interface connected to a 10/100 switch port. Show interface on the Cisco reports Full duplex/10mb/s but the switch shows 100mb/s link. I am getting interface resets on this ethernet interface at a rate of about 75...

Is it possible to configure a conditional policy routing?For example, I want to apply this policy route-map on LAN interface only when WAN interface is up; if WAN is down then don't apply the policy.

Can someone tell me why when I enter the "show proc cpu" command at times it comes back and reads 0%

I've a Catalyst 4507 switch(IOS : Version 12.1(13)EW1), and have to match one MAC address to specified port.So I issued the command like this;mac-address-table static 1111.2222.3333 vlan 100 int g1/1But, the result was4507#sh mac-add | inc 3333 100 ...

Anyone heard rumors as to when VTP version 3 might become available for 6500 platform in native (IOS) mode? Apparently it is available for hybrid (CAT-OS) mode with CAT-OS 8.x code. Is is available on any other IOS platforms?

Dear Netpro,I have two sites that are separate by a laser link (100Mbps). There is currently a stack of 3 x 3548XL's and two 3550 EMI's (3550-48 port 3550-12g) and at the main site. All switches are connected via fibre to the 3550-12g and have redund...

This is a quick informative question.If I have a 2612 with one Ethernet port and a token-ring port, will I be able to configure the token-ring interface with static IPs and terminate an IPSec tunnel on it. I will not be running token-ring (just that ...

How can we tell if our 4006 switch will do layer 3?Thanks

Hi,IF i have three data centers located at diffreent sites having numerous Wan links, which does cisco recommend.1) develop site wise vlans and all the sites communicate to each as normal.This will not be centralized.2) develop central VTP domain and...

Ihave a a couple of DS3 and DS1 circuits coming from a SONET demarc to my 7206 router. The DS3 is currently over coax and the DS1 are over STP.What is the max. distance allowed for both from the demarc before I drop packets for the 7206?This is what ...

I got this message from our Cisco works DFM..InCharge Domain : DFM Active: Switch TRUE 10.51.81.250 ErrorException - System is experiencing Port or Interface errors.Is there any way to find what specific problem i am facing.Thanks a lot.

Hi,I have configured a bandwidth QoS policing rule on 2 ports. This rule limit http port 80 trafic to 300kb/s.But when I test this rule I only get half the speed 150kb/s. And if I set the max. speed to 600kb/s I get half the speed again 300kb/s. No m...

I have a 1750 router connected to a switch via the fast ethernet port F0 and a FRAD (Newbridge) also connected via its ethernet port to the switch.A wic-1enet port connects a segment of my network to the 1750 router. The segment connected via to wic-...

Hi, Somebody knows like removing automatically the rmon commands that writes RTM in the devices?