Other Network Architecture Subjects

Using RME 3.5 IDU 7Shedule config retrieval every day at 9:00 PM (ie : 7 avr. 2004 21:00:00 GMT+02:00 (Every 1 days)). When i look in configupdate.log, i see that config retrieval start à 2:00 AM.Where does it come from ? Using RME on WIN2K US Server...

Hi folks, here is my issue:I am atempting to set up a 3745 running 12.3.6 Advancd Enterprise with a NM-2CE1T1-PRI and 30 Digital modems as a NAS to support a number of individual users over Async dial up.I can connect to the NAS, and use RADIUS to co...

Hi,Have a strange issue where we have 2 3745's at head end with 3 VWIC-2MFT-T1 in chassis WIC slots. 6 T1s total at head end. 4 Remote sites - 2620XM or 2650XM with a single VWIC-2MFT-T1 in the chassis WIC slot.Each 3745 has a connection to 2 sites. ...

On three separate occasions, one of the WS-X4148-RJ cards on a 4506 chassis goes into "inactive" state. Any thing connected on this module stops communicating. When I accomplish the command "show port status", instead of the usual connected/not conn...

A Cisco 2950G-24-EI switch is directly attached to an Alcatel Omnicore 5022 which is configured as the Root Bridge for spanning-tree. The 2950G and the Omnicore are configured to run 802.1s spanning-tree. However, the 2950G cannot see the Omnicore as...

Have a problem with controller T3 on 7505IOS level 12.2.7atrying to configured as 'no channelized'.so :TORRTER02(config)#controller t3 6/1/0TORRTER02(config-controller)#no ? cablelength cable length in feet (0-450) clock Specify the clock s...

I want to configure a 7206 pa-t3+ for frame-relayand many sub interfaces. I am looking for an example.What do the following fields in the sh int ser1/0 mean? rxLOS active, rxLOF inactive, rxAIS inactive txAIS inactive, rxRAI inactive, txRAI active

Hi,I am planning to setup a network like below:LAN - R1 ------PPP Link------ R2 - LAN | | W1 --------------------------W2R1 for router1R2 for router2W1 for wireless1W2 for wireless2My aim is to provide a failover....

Can anyone tell me the meaning of the "late-dropped out pkts" field in the output of a "show frame-relay pvc" command? Here's a sample:Router#sh frame-relay pvc interface Serial3/5.49 49 PVC Statistics for interface Serial3/5.49 (Frame Relay DTE)DLCI...

I am going to start setting up vlans on my network. My problem is I have machines in a 255.255.128.0 mask, I want to create the vlans in this .128 mask and not have to move all the machines out of the .128 and back down one at a time. I did get thi...

Any guidance on removing a portchannel entirely from the config of a 6509? I set the port channel to off, disabled the individual port and removed trunking but it still shows up in my configuration.

Hi all together!I have abnormal stattistic of runts errors on ethernet of C3750 (both GE MM, FE UTP) in case I connected PIX firewall ports in trunk mode. LED on C3750 port blink yellow. All other errors counters in order. Total statistic is 1 runts ...