Other Network Architecture Subjects

Hi guys. Looking for some help please guys. I bought three cisco 2621xm routers recently. One boots up fine, and the other two clear the bootstrap 12.2 (8r) and then present the error - Memory not detected. I have transferred the good working memory...

Hi,  Is "write" command equivalent to copy running-config startup-config.

I have configured all my dhcp, nat, and access lists but i cant figure out why i cannot connect to the cable modem to get internet. Below is my sh ip route and sh ip int brief. Gateway of last resort is 192.168.0.1 to network 0.0.0.0 S* 0.0.0.0/0 [1/...

I have a cisco 3600 , and the switch is configureg with "The password-recovery mechanism is disabled.". And when the switch is start to load the IOS , this message apear. "Password recovery *disabled* and got break character.. auto booting". I just t...

Hello, I would like to know if my Cisco 6506 is support with the VSS option ? on the global i can see the command :  Cisco-6506(config)#switch virtual domain ? <1-255> Virtual switch domain number but on the Ten interface i cant see the option to V...

Our Subscription said that our modem is in plug and play (static) - If I will connect modem connected directly to PC in DHCP mode, but no access to the internet (unidentified)But if the modem will connect to the router first going to Devices, there i...

Hi,our cisco routers 2801 are vulnerable to CSCtd75033. Current IOS version is 12.4(1c). Can you help me to find right IOS for upgrade?Devices have 128 MB DRAM and 64 MB Flash. From download center looks fine for me version 12.4(19a). Software checke...

Hi  I have 5512-X ASA. with IOS version 9.2 . Whats else I will need to make it work like ASA FIREPRO mode?

Hi All,        >I am building iWAN POC  based on CSR 1000v which consists of Two HUB's and Three Branches.  >I am able to provision HUB's seemlessly via APIC-EM. > I am able to get the branch routers provisioned in plug and Play and discovery, But t...

I've got an 837 SOHO router with some old config. Once the image is decompressed console output ceases. I thought it was just a baud rate change in the config and so I initially just poked through the different standard baud rates with no luck. Then ...

Hi there Guys I have a cisco 2621 router.  It has worked before, although now it is coming up with the following message during boot up: System Bootstrap, version 12.2 (8r), Release Software (fc1) Copyright (c) 2003 by Cisco Systems, Inc Then I ge...