Other Network Architecture Subjects

hi; we have asr 1001x with Cisco IOS XE Software, Version 03.17.00.S and we are making nat overload with pool. ===config ip nat pool OUTNET x.x.x.2 x.x.x.254 prefix-length 24 ip nat inside source list 1 pool OUTNET overload access-list 1 permit y.y...

To Whom It May Concern, I am currently wondering, how do we enable the VPN on this cisco phone. I currently have a user that works remotely, and he requires VPN access to be able to do most of his job. Would we have to download the Cisco Anyconnect ...

Dear all, this is the message error that i get went i try a ping from my side to  the remote site  baosslvpn# sh crypto isakmp sa Active SA: 1Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey)Total IKE SA: 1 1 IKE Peer: 154.73....

Hi, I have cisco asa 5525 on which i have three anyconnect packages under 'Anyconnect client images'. anyconnect image disk0:/anyconnect-win-3.1.13015-k9.pkg 1anyconnect image disk0:/anyconnect-linux-3.1.13015-k9.pkg 2anyconnect image disk0:/anyco...

Hi - am trying to figure out how the ASR 100x redundant power supplies operate - is one is standby while the other assumes full load of the router or do they share the load? thanks

We have 4 MDS 9000 fibre switches in our DC. They are running 3.3(5A) NX-OS We have fabric manager running. Currently we run an antiquated system of logging into each device in our infrastructure to check it is "OK". This includes the cisco switches...

Hi all, We have a SCOM 2012 R2 installation and I have installed UCS Manager Integrations 3.1.1 on this SCOM server. I have 3 Cisco servers running Windows 2012 R2 64-bit.On the SCOM server I have the Management Pack and the Cisco UCS Management Serv...

Anyone would like to explain why using VRF interface as management? Without the VRF interface, what will happen? Thank you

I have 2 ACS 5.5 units (1 primary, 1 secondary) and I am trying to configure the failover capabilities between these devices.  So far, if the primary goes down, the secondary does not pick up the devices and I loose connectivity with those devices.  ...

Hi All, I am planning to create new network. Following are the sites 1) Primary site 2) DR Site 3) Client site A 4) Client site B 5) Client site C. I am planning to configure this network on OSPF and the sites will have area as given below Area 0 For...