Other Network Architecture Subjects

Can anyone tell me why this configuration does not work?All I am trying to do is rate-limit traffic on a port (any traffic)I can do it using storm control, but i dont want to use this as it has drawbacks.mls qos!class-map match-all port13 match any!...

I am no router guru. I used cofigmaker (yes everyone can now grumble) to set up a 1720 router to provide NAT on the ethernet side to my one public IP number. It is working perfectly for internet access. I have this hooked to a T-1 using HDLC at my...

Hi I run one production CiscoWorks server with LMS 2.2 on solaris 2.8. Now I have installed an identically standby server. I want to make the standby server to be a copy of the production server (user data,device groups, netconfig user templates and ...

Currently our ISP injects a defualt route into our IGP using OSPF. Due to plans to migrate to AT&T's IPFR service, our IGP will be replaced by BGP. I've been simulating the new environment in a lab and have run into an issue with the default route ...

Greetings,I'm trying to limit what DFM sends via the mail adapter. I've modified the mail_notify.conf file as follows trying to remove some unwanted traps: GA_ChoiceSubscription::Device_Down { className = ".*" ins...

We're running LMS 2.1 on W2K server and would like to send the fatal errors from the DFM to our cell phones. We are running Novel's GroupWise mail system and I was wondering if there's a documentation on how to configure the mail server field for se...

HiI need to make a simple PBR but it just don't seem to work. Let me brief you... I have router with a default route to another router connected to the internet, however i want that one host (192.168.127.2) jump to other router (think it like a rudim...

Hello I have a pretty simple internet connection that supplies access for 2 PCs.The downstream bandwidth is 500KThe upstream bandwidth is 256KI want to restrict each PC to have 250K download speed, and 125K upload speed. But maybe be able to allocate...

I currently have a port-channel set up between a 6509 and a 3550. VTP runs over this channel as well. We currently have 10 vlans, however only 2 of these will need to be configured on the 3550 switch. So I would like to do some VTP prunning to keep t...

Hi all:Is Cisco's implementation of MSTP/RSTP compliant with the IEEE Specs (802.1s/w) ? If now, how does it differ?Any help is appreciated.Thanks,Vishal

At what minimum voltage level will the switches (3524) and the routers 3640's reboot ?

Somebody knows about support for 50/125 fiber optic on Cisco 7206VXR with PA-A3-OC3MM?

I connected a sbiffer to a switched port on a c3548. SPAN was not turned on. As I expected, I see alot of broadcast traffic.However, I am also seeing alot of source/destination traffic. Example would be an ARP reply to a broadcast. WHY? I though t...