Other Network Architecture Subjects

I want to identify what hardware module installed in the AS5200. please guide me based on the “show version” or what information required to identify.- 1 Eth- 2 Serial- Dual T1/PRI- I’m not sure for 24 teminal lines and 26 serial network interface.Th...

I have Cisco 3640 router. I upgraded the ios and when i rebooted the router the routercrashed. I went to the cisco romm modem and changed the config register to 0*0 and reset the router. Once the router booted again the romm modem i gave the commandx...

I have configured a router with exit to Internet. Has configured NAT to leave. The problem that I can not from internet because the packets change the number of port 23. As I can solve itRegards

We have run out of wire runs. So to increase our network we will be putting a few hubs on different switch ports to increase the amount of pcs on the network. I have heard that it is important to make sure that any hub that is connected to a switch p...

does Ciscoworks 5.3, 5th ed. (CD One) support c4506 now?

We are seeing this message in the logs and are not sure what this means . Have tried plugging this into the error message decoder which was no help at all . We are seeing this message against more than 1 port but the indicated MAC address ...

Hellohope someone could explain me something -as i understand the dlci is a uniqe number which identify a uniqe point to everynetwork. ( its symbolize the first point where the network is connected to the f/r cloud , or the uniqe dce of every networ...

Does anyone know how to turn off the web service on a 3548. Thank you.

I can set the time on the router, but, when I reboot the time has reverted to it's original time. Isett the time in enabled mode and use the command, "copy running startup" to sve the changes. Any pointers would be much appreciated.Gerard

This is a silly question but I need to get some clarification on this subnetting question.Given a network address 11.253.26.0/24 from a provider I want to have 3 networks with the following number of hosts.10, 35, & 95.....what would the networks and...

Running on Solaris, I want to create a host file, that CW2K will reference for host or device names "IF" it cannot resolve to DNS. DNS will resolve some but a few are not in DNS and I want to add them to a host file rather than edit the DNS server.W...

I have two very general questions regarding QOS best practices:1) Does anyone have a link that explains QOS, how to implement and the best practices for implementing on a WAN?2) Would QOS be done on the WAN router, the remote router or the switches...