Other Network Architecture Subjects

Hej,I am in planning of LAN re-design for Head office which consists of different networks - user LAN, WAN, DMZ, Internet, Special connection, sever LANPresent traffic generation across the networks, ofcourse in near by future these values except to ...

HII am having some problem with 1841 router. I deleted its image and now tying to download it from TFTP in rommon.  I am getting these messages.Readonly ROMMON initializedrommon 1 > IP_ADDRESS=192.168.1.3rommon 2 > IP_SUBNET_MASK=255.255.255.0rommon ...

hi all,i've a bgp router with Gigabit Interface and a internet circuit of 100M ..sometimes occour that the internet link go in saturation (downlink only) and the lacency go up ..i've tried to setup a qos with class-map on GigabitEthernet0/0 (facing i...

Dear,I have a home lab wthe a 2600 access server (16 port octal). From this 2600 router I want to connect to a Raritan 8 ports RPC.This RPC (Remote power control) has a rs232 serial port (RJ45)I tried a lot and still I do not get connected to the RP...

Hi,I recently purchased a Cisco 4402 on ebay and I have v3 software on it currently and have no way of upgrading it without downloading the software from the cisco site - which I don't have access to as I don't have warranty on it and don't wan't to ...

Hi guys, i've been doing an EEM scripting were an email action in an applet to send the email and use the syslog event detector to match your syslog message. Below are my config:ROUTER(config)#event manager applet mode-downROUTER(config-applet)#event...

Hi Expertwhether cisco prime infrastructrue same like splunk software?or both the above software different ?Thanks

At my work, we are trying to choose between Dell and Cisco for our network upgrade.  Dell has got Cisco beat on the price and a lot of the specs too.Our current setup:Core:     Cisco 4510     1Gbps copper to servers     1Gbps fiber to 4 network close...

Hi, everyone!    Our client has an office building, which he rents out to its customers.The customer plans to provide internet to its tenants. It is planned to 30 clients, and the total channel capacity of the provider 300MbOn the border with the pro...

I have a switched network of C2980 & C3548 switches with multiple VLANs. I would like to understand the difference between Mulit-VLAN ports and trunk ports.What circumstances would dictate using one over the other?If I configure the router port as M...

I know this isn't the the best topic to put on a Cisco forum, but I have a few things that I am wondering with Dell's networking and I am hoping someone can point me in the right direction.The company I work for is looking to upgrade the network to 1...