Other Network Architecture Subjects

I recently installed a firmware upgrade on my E3000 to firmware version 1.0.04.build 6.  Since the upgrade I am unable to see any of my files on my network computer which is running windows 7.  Before everything was fine and I could stream to my dvd ...

I understand that the NM-1FE Fastethernet modules are not compatible with Cisco 2600 series routers, just the Ethernet 1-E module.  With that being said, are there ANY modules supported by the 2600, 2621 or 2621XM series routers that have fastetherne...

                   i have configured 3 server farms on my ACE Module with 3 VIP , i need to make all servers in one server farm can ping on to the VIP of the onther server farm , so i need your help please ASAP ?!!

Hello every one,we are going to introduce a new office.as we have already running a setup in older one.we have already an ASA 5510 and a RV042 router in old setup.Now i purchased 2 3560 48 port switches with enhence image and a 2611xm router.  we hav...

Hi All,Right Now we are using Cisco switch model c4006.and we are looking to replacement for the same . Below are our requirements.1: Around 120 Ports (100 Mbps)2: Around 30 Ports   (1Giga)3: Layer2/Layer3Can anyone suggest Which is the best model fo...

What router should I buy for my data center in costa rica?---Posted by WebUser Jinal Jhaveri from Cisco Support Community App

Hi All,I have been asked to look into upgrading our Network from 1Gb to 10Gb. We currently have the following architecture and was hoping you guys could have some suggestions on suitable Cisco kit for what i am trying to acheive.2 x Colo Mirrored 6 x...

Hi guys.I am about to support a new customer which has two sites. There is a cisco router in one site and a juniper in the other site.I am used to monitor Delay, jitter and packet loss when using Cisco equipments.I am not used to juniper... is that p...

I have to replace cisco equipmenet and looking for an advisemy current network layout:my destination layout want to something like that:I have a couple questions:1) is that new network layout would be a good solution or is it better to do also 3750 r...